|
SWT Brine Valves add reliability and security to your water treatment
system with four primary checks to prevent excessive brine draw or overfill. During a power outage, the main control
valve can freeze in “brine draw” or “brine refill” mode. These conditions can cause water to
overfill the brine tank or allow a wasted amout of brine solution to be sent to the drain. SWT brine valves prevent
these potentially damaging results because each brine valve is equipped with a safety back-up float and check to close
the paths to and from the brine tank. |
|
This valve is widley used with automatic multicycle control valves such as Autotrol, Fleck, Clack, etc. There are
four distinct adjustable designs which allow the valve to be used in a wide variety of applications. These designs
are as follows:
|
|
Type A: This type of valve has a factory preset brine draw level and adjustable brine refill float.
|
|
Type B: This type of valve has an adjustable brine draw level and brine refill float.
|
|
Type C: This type of valve has a factory preset brine draw level and adjustable brine refill float
with overhead refill. Overhead design is used in large or odd-shaped brine tanks where refill water needs to be
dispersed over a large area. The overhead refill design allows for connection of tubing to be located as needed.
|
|
Type D: This type of valve has an adjustable
brine draw level and brine refill float with overhead refill.
|
| |
|
Features Include:
|
| • |
Requires no electrical power to operate
|
| • |
All components operate hydraulically
|
| • |
Four distinct adjustable designs
|
| • |
Tested for operation and leakage at the factory prior to shipment
|
| • |
All components are compatible with saturated brine solution
|
| • |
Maximum operating temperature: 140°F (60°C)
|
| • |
Fits 4 inch brine wells (adaptable to 5 inch)
|
|
